Stopped rabbet¶

from woodwright.examples import cuts

design = cuts.stopped_rabbet(width=12.5)

board  600 x 300 x 40 mm  oak
       - stopped rabbet 10 mm, 20 deep, in top_face at back_edge, 40 mm short of right_end

def stopped_rabbet(
    width: float = 10, depth: float = 20, stop: float = 40, stock: Stock = THICK_OAK
) -> Assembly:
    """A rabbet along the back edge stopped short of the right end, e.g. in the
    side of a case for a back that stops below the top."""
    asm, board = _board("stopped_rabbet", stock)
    board.cut(
        Rabbet(
            board.top_face,
            at=board.back_edge,
            width=width,
            depth=depth,
            stopped={board.right_end: stop},
        )
    )
    return asm