Half lap frame¶

from woodwright.examples import frames

design = frames.half_lap_frame(stile_length=500)

stile  400 x 50 x 20 mm  oak, 2 pieces: stile_left, stile_right
       - end rabbet 50 mm, 10 deep, in bottom_face at right_end
       - end rabbet 50 mm, 10 deep, in bottom_face at left_end
rail   350 x 50 x 20 mm  oak, 2 pieces: rail_top, rail_bottom
       - lap 10 mm thick, 50 long, on left_end
       - lap 10 mm thick, 50 long, on right_end

def half_lap_frame(
    stile_length: float = 400,
    rail_length: float = 250,
    width: float = 50,
    stock: Stock = OAK,
) -> Assembly:
    """A frame with half-lap corners."""

    def corner(rail_end: SideRef, stile_edge: SideRef, position: Position, outer: SideRef) -> Joint:
        return HalfLap(lap=rail_end, socket=stile_edge, position=position)

    asm, _ = _frame("half_lap_frame", corner, stile_length, rail_length, width, stock)
    return asm