Mortise tenon frame¶

from woodwright.examples import frames

design = frames.mortise_tenon_frame(stile_length=750)

stile  600 x 60 x 20 mm  oak, 2 pieces: stile_left, stile_right
       - 2 x mortise 40 x 8 mm, 42 deep, in back_edge
rail   380 x 60 x 20 mm  oak, 2 pieces: rail_top, rail_bottom
       - tenon 40 x 8 mm, 40 long, on left_end
       - tenon 40 x 8 mm, 40 long, on right_end

def mortise_tenon_frame(
    stile_length: float = 600,
    rail_length: float = 300,
    width: float = 60,
    shoulder: float = 10,
    stock: Stock = OAK,
) -> Assembly:
    """Two stiles and two rails, the rails tenoned into the stiles at their ends."""

    def corner(rail_end: SideRef, stile_edge: SideRef, position: Position, outer: SideRef) -> Joint:
        return MortiseTenon(
            tenon=rail_end, mortise=stile_edge, position=position, shoulder=shoulder
        )

    asm, _ = _frame("mortise_tenon_frame", corner, stile_length, rail_length, width, stock)
    return asm