Stub tenon corner¶

from woodwright.examples import joints

design = joints.stub_tenon_corner(stile_length=375)

stile  300 x 60 x 20 mm  oak
       - mortise 45 x 8 mm, 42 deep, in back_edge
rail   240 x 60 x 20 mm  oak
       - tenon 45 x 8 mm, 40 long, on left_end

def stub_tenon_corner(
    stile_length: float = 300,
    rail_length: float = 200,
    width: float = 60,
    tenon_length: float = 40,
    outer_shoulder: float = 15,
    stock: Stock = OAK,
) -> Assembly:
    """A frame corner with a stub tenon: shoulders on the faces and the outer edge only.

    On the inner edge the tenon is flush with the rail, with no shoulder;
    on the outer edge a plain shoulder sets the mortise back from the end
    of the stile, so it stays closed there. No haunch. Blind, two thirds of
    the stile wide. Compare `haunched_stub_tenon_corner` and
    `haunched_mortise_tenon_corner`, same stock and tenon length.
    """
    return _corner_tenon(
        "stub_tenon_corner",
        stile_length,
        rail_length,
        width,
        tenon_length,
        outer_shoulder=outer_shoulder,
        inner_shoulder=0,
        haunch_length=None,
        stock=stock,
    )